Daily maintenance and maintenance
1. In daily use, we must pay attention to whether all the door parts on the equipment are closed, and then the door can be turned on.
2. Check the wear-resistant parts of each part of the equipment, and replace them immediately if the wear exceeds the standard.
3, To do a good job of gas leakage inspection of dust removal pipeline, to ensure that there is no gas leakage to ensure normal dust removal.
4. Check the filter bag of the dust collector to ensure that there is no dust and debris in the filter bag.
5. The motor screw of Roller Conveyor Shot Blasting Machine
should be inspected to ensure that it is not loose.
6. Check the filter screen of the separator to ensure that there is no ash accumulation in the filter screen.
7. The protective plate of the equipment should be inspected to ensure that the protective plate of Roller Conveyor Shot Blasting Machine
will not be damaged.
8. Check the pill supply gate of the equipment to ensure that the electronic control device of the gate valve has been closed.
9, To check the equipment console signal light, to ensure that it works normally.
10. Check the switch of each limit of the equipment to ensure its normal state.
11. The control box of the equipment and electrical appliances should be cleaned regularly and the dust on the surface should be removed.
Monthly, quarterly and annual maintenance
1, The monthly test
Check the fan and duct of the equipment every month to see the degree of wear and replace it according to the situation. Every month to check the parts of the transmission, check whether its operation is normal, can be used to do lubrication maintenance of the chain. Every month, check whether the connecting parts of the equipment are loose, and tighten them according to the situation.
2, The quarterly test
Check the tightness of bolts for fan, click, sprocket and other components quarterly. Every quarter to check the motor bearing and electric control box, and lubrication maintenance. The grease replacement of the main bearing of Roller Conveyor Shot Blasting Machine shall be carried out every quarter. The protection plate of Roller Conveyor Shot Blasting Machine
shall be inspected every quarter, and the serious wear and tear shall be replaced in time.
3, The yearly test
Every year, all bearings of the equipment should be checked and lubricated. Every year, all the electric bearings of the equipment should be checked. Every year, the bag of the dust collector should be checked. If there is damage, it should be replaced. Check the situation of the inner protective plate in the ejector area of the equipment every year, and replace it in time if the wear is serious.
Whether daily, monthly, quarterly or annual, it is important to get used to regular, regular inspection, regular lubrication, regular cleaning and regular maintenance of Roller Conveyor Shot Blasting Machine
. As long as these regular maintenance can be done well.